8 • EN
TECHNICAL SPECIFICATIONS
Model number
1093
INPUT
220–240VAC, 50–60Hz, max 2.0A
OUTPUT
15A, 12V
Start voltage
2.0V Lead Acid batteries
8.0V LiFePO
4
batteries
Back current drain*
Less than 2.3Ah/month
Ripple**
Less than 4%
Ambient
temperature
-20°C to +50°C (-4°F to +122°F)
Battery types
WET, EFB, Ca/Ca, AGM and GEL types of 12V (6cells) lead-
acid batteries. LiFePO
4
, life, li-iron, LFP types of 12V (4cells)
Lithium Iron Phosphate batteries.
Battery capacity
28–300Ah, Lead Acid battery types
20–280Ah, LiFePO
4
battery types
Insulation class
IP44
Warranty
2 years
*) Back current drain is the current that drains the battery if the charger is not connected
to the mains. CTEK chargers have a very low back current.
**) The quality of the charging voltage and charging current is very important. A high
current ripple heats up the battery which has an aging effect on the positive electrode.
High voltage ripple could harm other equipment that is connected to the battery. CTEK
battery chargers produce very clean voltage and current with low ripple.
LIMITED WARRANTY
CTEK, issues this limited warranty to the original purchaser of this product. This limited
warranty is not transferable. The warranty applies to manufacturing faults and material
defects. The customer must return the product together with the receipt of purchase to
the point of purchase. This warranty is void if the product has been opened, handled
carelessly or repaired by anyone other than CTEK or its authorised representatives. One
of the screw holes in the bottom of the product may be sealed. Removing or damaging
the seal will void the warranty. CTEK makes no warranty other than this limited
warranty and is not liable for any other costs other than those mentioned above, i.e. no
consequential damages. Moreover, CTEK is not obligated to any other warranty other
than this warranty.
SUPPORT
For support, FAQ, latest revised manual and more information about CTEK products:
www.ctek.com.
50017977B
To Previous Page
Loading...
