1 - 1
3000 Series Pre-Delivery Check List
CUSTOMER NAME_____________________________________ MODEL NUMBER_________________________
CUSTOMER ADDRESS__________________________________ SERIAL NUMBER_________________________
CITY_______________________ STATE______ ZIP__________ TECHNICIAN ____________________________
ENGINE INFORMATION TRANSMISSION INFORMATION
Engine Make __________________ Transmission make __________________
Model No. __________________ Model No. __________________
Serial No. __________________ Serial No. __________________
Spec No. __________________
CUSTOMER SIGNATURE_________________________________________________ DATE__________________
Operator’s Manual Complete?
❑ Owners Manual
❑ Attachment Guide
❑ Merchandising Catalog
Battery and connections
❑ Remove battery and fill to proper level
❑ Allow battery to stand for 30 minutes
❑ Charge at 4 AMPS max. to 1.265 specific gravity
Tire Pressure
❑ Front
❑ Rear
*Refer to owners manual for proper PSI
Check all lights and indicators
❑ Headlights, Tail and Backup lights
❑ Low oil light
❑ Hour meter
Lubrication
❑ Transmission oil level
❑ Engine oil level
*Check tractor owners manual for type and grade
Air cleaner and connections
❑ Remove air cleaner cover to verify air cleaner is
installed
❑ Insure retaining bolt seal is installed
❑ Insure proper installation of breather hose
❑ Proper operation of throttle and choke cables
Steering
❑ Check for 1/8 to 1/4 inch toe in.
❑ Insure equal travel right and left
❑ Check steering wheel tilt
Hydrostatic / Gear drive and brakes
❑ Check brakes
❑ Check for neutral when brake pedal is depressed
❑ Check for neutral when forward and reverse
pedals are released
❑ Check cruise control
Grease pivot points
❑ Front axle pivot bar
❑ Each steering knuckle
❑ Each front wheel
❑ Steering housing
❑ All grease points on mower deck
*Refer to specific mower owners manual
Install attachments mower / snow blower etc.
❑ Check PTO
❑ Inspect linkage
❑ Deck level adjustment
Safety operations
❑ Check no cut in reverse
❑ Check engine shutdown with PTO engaged and
seat empty
❑ Check engine shutdown with empty seat and
parking brake not engaged
Check engine speeds / Controls
❑ Low idle - 1200 RPM
❑ High idle - 3600 RPM
Final inspection
❑ Overall appearance
❑ Clean and polish
Hydraulics
❑ Check lift valve
❑ Check lift cylinder
To Next Page
Loading...
