Cub Cadet GT1554 VT User Manual

Cutting Deck Removal
To remove the cutting deck, proceed as follows:

position and engage the parking brake.
Lower the deck by moving the deck lift lever into the 2.
bottom notch on the right fender.


NOTE: If there is too much tension on the belt for it to be

a ⁄ drive ratchet wrench (set to tighten) into the square
hole found in the left-hand deck idler bracket and pivot it


WARNING! Avoid pinching injuries. Never place
your fingers on the idler spring or between the belt
and a pulley while removing the belt.
Looking at the cutting deck from the left side of the tractor, 4.
locate the deck support pin on the rear left side of the
deck.
Figure 7-1
Belt Guard
Figure 7-2
Service
7
25

Cub Cadet GT1554 VT Specifications

General

Transmission	Hydrostatic
Engine Fuel	Gasoline
Drive	2WD
Deck Type	Fabricated
Front Tire Size	16 x 6.5-8
Cutting Width	54 in (137 cm)
Deck Material	Steel
Turning Radius	18 in (45.7 cm)