EasyManuals Logo

Cub Cadet LTX 1040 User Manual

Cub Cadet LTX 1040
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Driving The Tractor
Avoid sudden starts, excessive speed
and sudden stops.
Lightly press the brake pedal to release the parking brake. 
Move the throttle lever into the FAST (rabbit) position.
2.

To travel in REVERSE, check that the area behind is clear and 
with your tractor parking break on, move the shift lever
into the reverse position. Lightly press the brake pedal to
release the parking break and then slowly press the drive
pedal until the desired speed is achieved.
CAUTION: 
direction of travel when the tractor is in motion.
Always bring the tractor to a complete stop before
moving the shift lever from forward to reverse or
vice versa.
Do not leave the seat of the tractor


parking brake. If leaving the tractor unattended, also
turn the engine off and remove the ignition key.
Reverse Caution Mode


engaged.
NOTE: Mowing in reverse is not recommended.
Use extreme caution while operating

look down and behind before and while backing. Do
not operate the tractor when children or others are
around. Stop the tractor immediately if someone
enters the area.

NOTE: The operator MUST be seated in the tractor seat.
Start the engine as previously instructed on the previous 
page.
2.

key switch module. See Fig. 5-2.

Button) at the top, right corner of the key switch module.
The red indicator light at the top, left corner of the key

4.

Always look down and behind before and while backing to 5.
make sure no children are around. After resuming forward


a.

The operator leaves the seat.b.




Stop
Position
Start
Position


Position


16 se c t i O n 5— Op e r a t i O n

Other manuals for Cub Cadet LTX 1040

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet LTX 1040 and is the answer not in the manual?

Cub Cadet LTX 1040 Specifications

General IconGeneral
Engine BrandKohler
Engine ModelCourage
Cutting Width42 inches
Transmission TypeHydrostatic
Deck MaterialSteel
Turning Radius18 inches
Number of SpeedsInfinite
Cutting Height1.5 - 4 inches
Number of Blades2
Front Tire Size15x6-6
Rear Tire Size20x8-8
Blade EngagementManual
Warranty3 years limited
Engine TypeSingle-cylinder OHV

Related product manuals