Changing the Deck Belt
WARNING! The V-belts found on your tractor are
specially designed to engage and disengage safely.
not disengaging completely. For a proper working
machine, use factory approved belts.
All belts on your tractor are subject to wear and should be
replaced if any signs of wear are present . To change or replace
the deck belt on your tractor, proceed as follows:
Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
2.
clutch. See Fig 7-5.
NOTE: If there is too much tension on the belt for it to be
a ⁄ drive ratchet wrench (set to tighten) into the square
hole found in the left-hand deck idler bracket and pivot it
See Fig. 7-6.
WARNING! Avoid pinching injuries. Never place
your fingers on the idler spring or between the belt
and a pulley while removing the belt.
Figure 7-5
Figure 7-6
27se c t i O n 7 — se r v i c e
To Next Page
Loading...
