EasyManuals Logo

Cub Cadet LTX1040 User Manual

Cub Cadet LTX1040
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Adjusting the Seat
To adjust the position of the seat, pull up and hold the seat
adjustment lever. Slide the seat forward or rearward to the desired
position; then release the adjustment lever. Make sure seat is
locked into position before operating the tractor. See Fig. 3-4.
k. j
Figure 3-4
WARNING! Before operating the tractor, make sure
the seat is engaged in the seat-stop. Engage the
parking brake. Stand behind the machine and pull
back on seat until it clicks into place.
Gasand Oil
The fuel tank is located under the hood and has a capacity of
three and-a-half gallons. Remove the fuel cap by turning it
counterclockwise. Use only clean, fresh (no more than 30 days
old), unleaded gasoline. Do not overfill the tank.
For California models equipped with a tethered, ratcheting cap,
STOP filling tank once fuel is seen inside the filler neck. This
ensures that a proper expansion volume is created. Do NOT top
offtank. See Figure 3-5.
Figure 3-5
,J
WARNING! Use extreme care when handling
gasoline. Gasoline is extremely flammable and the
vapors are explosive. Never fuel the machine
indoors or while the engine is hot or running.
Extinguish cigarettes, cigars, pipes and other
sources of ignition.
NOTE: Your tractor is shipped with oil in the engine. However,
you MUST check the oil level before operating.
CAUTION: Always check the engine oil level before
each use as instructed in the Kohler Owner's Manual.
Add oil as necessary. Failure to do so may result in
serious damage to your engine.
SECTION 2 -- ASSEMBLY& SET-UP 11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet LTX1040 and is the answer not in the manual?

Cub Cadet LTX1040 Specifications

General IconGeneral
Engine BrandKohler
Engine ModelCourage
Cutting Width42 inches
Transmission TypeHydrostatic
Deck EngagementManual
Deck Size42 inches
Blades2
Turning Radius18 inches
Deck MaterialSteel
Cutting Height1.5 - 4 in
Front Tires15 x 6 in
Rear Tires20 x 8 in
Warranty3-year limited

Related product manuals