Cub Cadet XT1-LT42 User Manual

Troubleshooting
8
30
Problem Cause Remedy
Excessive vibration 1. Cutting blade loose.
2. Damaged, unbalanced or bent cutting blade.
1. Tighten blade and spindle.
2. Replace blade.
Uneven cut 1. Deck not leveled properly.
2. Dull or damaged blade.
3. Uneven tire pressure.
1. Perform side-to-side deck adjustment.
2. Sharpen or replace blade.
3. Check and correct tire pressure in all four
tires.

Cub Cadet XT1-LT42 Specifications

General

Horsepower	18 HP
Cutting Width	42 inches
Transmission	Hydrostatic
Turning Radius	18 inches
Cylinders	1
Blades	2
Deck Material	13-gauge steel
Front Tires	15x6 inches
Rear Tires	20x8 inches
Warranty	3-year limited
Engine Type	Single-cylinder OHV
Drive System	Rear wheel drive
Cutting Height	1-4 inches
Fuel Capacity	3 gallons