Cuddeback Ambush - Page 11

TheavailablesettingsareselectedbypressingtheBkey:
P1:1 =
10footashrange(bestsettingforindooruse)
P1:2=20footashrange
P1:3 =
30footashrange(bestsettingforgeneraluse)
P1:4=40+footashrange(bestsettingforelds)
Step 2: Press the A key to display P2 (video length)
P2controlstheAmbush
®
video length.
TheavailablesettingsareselectedbypressingtheBkey:
P2:1=10secondvideo
P2:2=20secondvideo
P2:3=30secondvideo
Step 3:
Press the A key to display P3 (video operating time)
P3controlstheAmbush
®
video operating time
(This setting is ignored on the Ambush
®
and will be displayed as
P3:--)
TheavailablesettingsareselectedbypressingtheBkey:
P3:1 = record videos only at night
P3:2 = record videos only during the day
P3:3 = record videos during day & night
Step 4: Press the A key to display P4 (operating time)
P4controlsthetimeAmbush
®
will take pictures.
TheavailablesettingsareselectedbypressingtheBkey:
P4:1 = operate only at night
P4:2 = operate only during the day
P4:3 = operate during day & night
15
Step 5: Press the A key to display P5 (quality)
P5 controls the Ambush
®
image and video quality.
TheavailablesettingsareselectedbypressingtheBkey:
P5:1 = standard resolution 5MP (smallle) images/video
P5:2 = high quality 5MP (largele) images/video
Note – image quality is improved by optimizing the
JPGandVIDEOcompressionalgorithm.Imageswill
be clearer when zooming, but file size is significantly
increased. Most users will not benefit from this feature,
which is mainly intended for research professionals that
require the best image quality possible.
Step 6: Press the A key to display P6 (camera ID)
P6isacameraidenticationnumberthatisprintedonto
theimage.UsetheBkeytosetavaluefrom0thru99.
If0isselectedtheIDnumberwillnotbeprinted.
Step 7: Press the A key to display P7 (FAP Mode)
P7enablesordisablesasuperfastcameradelay,called
Fast-as-Possible,orFAP.WhenP7ison,thecamerawill
rearm immediately after the image or video is saved to the
SDcard.Thiscanresultinacameradelayinthe1to2
secondrange.WhenP7ison,the5secondcameradelay
positionbecomesFAP.Theremainingdialpositionsare
not affected. Note – using FAP mode can result in
blank images.
PressBtoenableordisableFAP:
P7:0=FAPmodedisabled
P7:1=FAPmodeenabled
14