Cuisinart DCC2650E - To Set the Time; Manual Programming; Automatic Programming

12
7. Heater plate temperature : 3 possible temperatures to keep co ee warm after brewing: ,
or .
8. Function dial:
a. PROG: to set the desired auto on time.
b. AUTO ON: auto-on feature to program the starting time of the brew cycle.
c. AUTO OFF: auto-o feature up to 38 minutes after brew cycle is  nished.
d.
button: to start the brew cycle immediately.
e. button: to set the time of the day.
N.B. The co ee will stop pouring when the co ee pot is removed from the heating plate so that
you can still pour a cup mid-brew.
B. TO SET THE TIME
• Turn the function dial to
position.
• Press and hold the HR or MIN buttons until display blinks. Then push HR or MIN button to scroll
through the digits. When the numbers stop blinking the time is set.
NOTE: When the number count passes 12, “PM” will be displayed on the LCD to set the time from
noon to midnight. When there is no indication, you will set AM times from 0 to noon.
C. NO PROGRAMMING
• Fill the reservoir with cold water depending on the desired number of cups (see height markings
inside the reservoir).
• The co ee pot height markings represent the number of cups obtained. The di erence between
this scale and the water reservoir marks results from the amount of water lost in brewing the
co ee.
• Insert a #4 paper  lter in the  lter holder. Add the desired amount of ground co ee in the  lter.
Use one measuring scoop per cup. This average dose can be adjusted to suit your taste.
• Close the lid. Make sure the co ee pot is in its position on the heating plate before switching the
co eemaker on.
• Select co ee strength by pressing the
button for regular co ee or button for strong
co ee.
• Turn the function dial to .
N.B. For fewer than 5 cups, turn the function dial to
then push .
• Press
. The red indicator light illuminates and the brewing cycle starts. The end of brewing
cycle is signalled by 5 beep sounds.
• Press
to switch the unit o . The red indicator light goes o .
D. AUTOMATIC PROGRAMMING
• Turn the function dial to PROG. The numbers blink 5 times then stop.
• Press and hold the HR or MIN buttons until display blinks. Then push HR or MIN button to scroll
through the digits. When the numbers stop blinking, time is set.
• Turn the function dial to AUTO OFF. The numbers blink 5 times then stop.
• Press and hold the HR or MIN buttons until display blinks. Then push HR or MIN button to scroll
through the digits. When the numbers stop blinking, time is set.