8
3. Insert the auger sleeve (11) through the opening in the
mixing bowl. Insert with opening facing up.
4. Insert the auger (10) into the auger sleeve (11).
5. Select the pasta disc (7a–f) you will use.
6. Assemble the pasta disc holder (4) with the selected pasta
disc (7a-f), and position onto the auger. Pasta disc should
be facing down.
7. Use the locknut (5) to secure and lock the pasta disc holder
(4) into place.
8. For extruding pasta, push the cutting tool (3) onto the disc
holder (4) until secure. Position so the window of the cutting
tool is framing the pasta disc.
To Next Page
Loading...
Need help?
General
