12
D OPERATION INSTRUCTIONS
Assemble the Cuisinart Seasoning Mill as detailed in Section A.
Ensure the unit is fully charged as detailed in Section B
Hold the unit with the end that you wish to grind from facing
downwards.
Press the On/Off button in the centre of the unit housing to begin
grinding. NOTE: Only the bottom container will yield any grinding
results. Even though the grinding container facing upward will
rotate, no grinding will actually take place.
To grind from the other end of the unit - simply flip the unit over.
E CHARGING & BATTERY LIFE
Your Cuisinart Seasoning Mill is equipped with NiMH batteries. We
have selected these batteries to give you maximum battery life and
long running times. Avoid wetting battery contacts. Before first use,
the batteries must be charged for 12 hours.
If batteries should run down completely, it will take between 8 and
12 hours to fully recharge them. Normally, you won’t run batteries
down completely, since the running time with a full charge is up to
20 minutes. It varies depending on your usage, but most grinding
tasks take around 5 seconds.
CONTINUOUS CHARGING
The unit is designed so that the batteries may remain on continuous
charge. It is recommended that the Seasoning Mill charger be kept
plugged into a wall socket, so that the mill will always be ready to
use. Leaving the unit on continuous charge is inexpensive in terms
of the amount of electricity being used. Use only with the charger
provided with the appliance. Do not attempt to use this charger with
any other product. Likewise, do not attempt to charge this appliance
with any other charger.
HOLDING THE CHARGE
The batteries hold most of their charge even when not plugged in and
charging, losing only about 30% of total charge per month.
To Next Page
Loading...
