Preparation Component Description
The water conditioner is shipped from the factory in a minimum of three cartons. Remove all
components from their cartons and inspect them before starting installation.
Control Valve Assembly - Includes the 5-cycle regeneration control valve and the Accusoft
®
Microprocessor. A small parts pack will contain additional installation hardware. An Owner’s Guide
is included.
Media Tank - 8” and 10” media tanks are shipped filled with Cullex
®
ion exchange resin,
underbedding and outlet manifold. For 12” tanks, the Cullex
®
ion exchange resin and underbedding
are loaded at the installation site.
Salt Storage Tank Assembly - Includes salt storage container with support plate and Dubl-Safe
™
brine refill valve and chamber.
Bypass Valve - Includes the Cul-Flo-Valv
®
, interconnecting couplings, and the screws necessary for
assembly (Bypass Valve included with Control for Medallist Plus).
Tools and Materials
The following tools and supplies will be needed, depending on installation method.
All Installations
For installation in Massachusetts, Massachusetts Plumbing Code 248 CMR shall be
adhered to. Consult your licensed plumber for installation of this system. This system
and its installation must comply with state and local regulations. The use of saddle
valves are not permitted.
• Safety glasses
• Phillips screwdrivers, small and medium tip.
• Gauge assembly (PN 00304450 or equivalent)
• Silicone lubricant (PN 00471507 or equivalent) - Do Not Use Petroleum-Based Lubricants
• A bucket, preferably light-colored
• Towels
Special Tools
• Torch, solder and flux for sweat copper connections
• Use only lead-free solder and flux for all sweat-solder connections, as required by state and
federal codes.
• Threading tools, pipe wrenches and thread sealer for threaded connections.
• Saw, solvent and cement for plastic pipe connections.
Materials
• Brine line, 3/8” (PN 01009819 or equivalent) for 8” and 10” tanks or 1/2” (PN00901800 or
equivalent) for 12” tanks
• Drain line, 1/2” (PN 00303082, gray, semi-flexible; or PN 00-3319-46, black, semi-rigid; or
equivalent)
• Thread sealing tape
• Pressure reducing valve (if pressure exceeds 125 psi [860 kPa], PN 00490900 or equivalent)
• Pipe and fittings suited to the type of installation
• Water softener salt (rock, solar or pellet salt formulated specifically for water softeners)
7
Note: Check and comply with your state and local codes. You must follow these guidelines.
To Next Page
Loading...
Need help?
General
