Need help?Do you have a question about the Culligan Platinum Series and is the answer not in the manual?
Explains the causes of hard water and the basic softening mechanism.
Warns against using the unit with unsafe water without disinfection.
Describes the Control Valve, Mineral Tank, and Brine System.
Explains regeneration based on water usage and programmed capacity.
Describes regeneration triggered by sensing hardness front.
Details how to initiate regeneration manually.
Identifies and describes the functions of keys and display elements.
Steps to set the current time on the control unit.
Verifies the power cord and outlet connections.
Instructions to check the house fuse or circuit breaker.
How power interruptions affect the timer and require reset.
Ensures bypass valves are in the correct service position.
Verifies water pressure and bypass valve status when no water flows.
Verifies salt level and allows time for dissolving if refilled.
How to identify and clear salt bridges in the tank.
Describes motor failure to start and how to clear the error.
Describes motor failure to stop and how to clear the error.
Describes incorrect cycle position and how to clear the error.
Explains mismatch between dip switches and detected valve.
Describes auto rinse out failure and clearing methods.
Explains the causes of hard water and the basic softening mechanism.
Warns against using the unit with unsafe water without disinfection.
Describes the Control Valve, Mineral Tank, and Brine System.
Explains regeneration based on water usage and programmed capacity.
Describes regeneration triggered by sensing hardness front.
Details how to initiate regeneration manually.
Identifies and describes the functions of keys and display elements.
Steps to set the current time on the control unit.
Verifies the power cord and outlet connections.
Instructions to check the house fuse or circuit breaker.
How power interruptions affect the timer and require reset.
Ensures bypass valves are in the correct service position.
Verifies water pressure and bypass valve status when no water flows.
Verifies salt level and allows time for dissolving if refilled.
How to identify and clear salt bridges in the tank.
Describes motor failure to start and how to clear the error.
Describes motor failure to stop and how to clear the error.
Describes incorrect cycle position and how to clear the error.
Explains mismatch between dip switches and detected valve.
Describes auto rinse out failure and clearing methods.
General| Water Filtration | Yes |
|---|---|
| Available Water Temperatures | Hot, Cold |
| Filter Life | 6 months |
| Operating Pressure | 40-100 PSI |
| Operating Temperature | 40°F - 100°F |
To Next Page