Replacement Parts
1 151039 Pressure-Relief Assembly
2 154159 White Cap
3 151121 o-ring (OR-38)
4 153049 Opaque Housing
5 150294 SW-1 Housing Wrench
(not included) not shown
For replacement parts, contact your nearest retailer or call
Culligan Consumer Services at 1-888-777-7962.
Performance Data
Important Notice: Read this performance data and compare the capabilities of
this system with your actual water treatment needs. It is recommended that, before
installing a water treatment system, you have your water supply tested to deter-
mine your actual water treatment needs.
This system has been tested according to NSF/ANSI 42 and 53 for reduction of the
substances listed below. The concentration of the indicated substances in water
entering the system was reduced to a concentration less than or equal to the per-
missible limit for water leaving the system, as specified in NSF/ANSI 42 and 53.
D-10 Cartridge
Substance Influent Challenge Max. Permissible Product Reduction Minimum Average
Concentration Water Concentration Requirements Reduction Reduction
Standard 42 Aesthetic Effects
Chlorine 2.0 mg/L ± 10% ≥ 50% 95%
Particulates at least 10,000 particles/mL ≥ 85% >85%
(1 to < 5 µm)
Class II
Flow Rate = 1 gpm (3.78Lpm)Capacity = 250 gallons (946 L) or 3 months
D-20 Cartridge
Substance Influent Challenge Max. Permissible Product Reduction Minimum Average
Concentration Water Concentration Requirements Reduction Reduction
Standard 42 Aesthetic Effects
Chlorine 2.0 mg/L ± 10% ≥ 50% 89%
Flow Rate = 1 gpm (3.78 Lpm)Capacity = 1000 gallons (3785 L) or 12 months
D-30 Cartridge
Substance Influent Challenge Max. Permissible Product Reduction Minimum Average
Concentration Water Concentration Requirements Reduction Reduction
Standard 42 Aesthetic Effects
Chlorine 2.0 mg/L ± 10% ≥ 50% 97%
Particulates at least 10,000 particles/mL ≥ 85% 96%
(0.5 to < 1µm)
Class I
Standard 53 Health Effects
Cysts
2)
Minimum 50,000/L 99.95% 99.99% 99.99%
Turbidity 11 ± 1 NTU 0.5 NTU 95.4% 97.4%
Asbestos 10
7
to 10
8
fibers/L >10 99% 99.95% 99.95%
Micrometers in length
Flow Rate = 0.9 gpm (3.4 Lpm)Capacity = 1000 gallons (3785 L) or 12 months
D-40 Cartridge
Substance Influent Challenge Max. Permissible Product Reduction Minimum Average
Concentration Water Concentration Requirements Reduction Reduction
Standard 42 Aesthetic Effects
Chlorine 2.0 mg/L ± 10% ≥ 50% 97%
Particulates at least 10,000 particles/mL ≥ 85% 96%
(0.5 to < 1µm)
Class I
Standard 53 Health Effects
Cysts
2)
Minimum 50,000/L 99.95% 99.99% 99.99%
Turbidity 11 ± 1 NTU 0.5 NTU 95.4% 97.4%
Asbestos 10
7
to 10
8
fibers/L >10 99% 99.95% 99.95%
Micrometers in length
Lead 6.5 pH 0.15 mg/L ± 10% 0.010 mg/L 99.3% 99.3%
Lead 8.5 pH 0.15 mg/L ± 10% 0.010 mg/L 94.1% 97.6%
Mercury 6.5 pH 0.006 mg/L ± 10% 0.002 mg/L 72% 88.5%
Mercury 8.5 pH 0.006 mg/L ± 10% 0.002 mg/L 95% 96.7%
Atrazine 0.009 mg/L ± 10% 0.003 mg/L 91.8% 93.8%
Lindane 0.002 mg/L ± 10% 0.0002 mg/L 97.3% 97.3%
Flow Rate = 0.6 gpm (2.27 Lpm)Capacity = 600 gallons (2271 L) or 6 months
2) Based on the use of microspheres or Cryptosporidium parvum oocysts
Testing was performed under standard laboratory conditions, actual performance may vary.
IOWA RESIDENTS ONLY:
Store or seller’s name
Address
City State Zip
Telephone
Seller’s signature
Customer’s signature Date
4
WARRANTY
This warranty applies to the Culligan US-550 Filter Housings only. It does NOT apply to any dis-
posable filter cartridge, which has a life expectancy that varies with the water being filtered. This
warranty covers defects in materials and workmanship only for five full years from original date of
delivery. Culligan will replace any part which in Culligan’s opinion is defective, unless: (1) any
part of the system has been subjected to any type of tampering, alteration, or improper use after
delivery, or (2) any part of the system has been repaired by anyone not approved by Culligan.
Our obligation does not include the cost of shipment of materials. Culligan is not responsible for
damage in transit, and claims for such damage should be presented to the carrier by the
customer.
This product has been designed solely for use as a housing for a disposable filter cartridge. It is
NOT warranted against freezing, and neither this product nor its parts is warranted against
defects or deterioration caused by uses for which this product was not expressly intended.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
EXPRESSED OR IMPLIED, WHETHER ORAL OR ARISING BY USAGE OF TRADE OR COURSE OF
DEALING, INCLUDING, WITHOUT LIMITATION, ANY WARRANTIES OF FITNESS OR
MERCHANTABILITY. THIS WARRANTY IS THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY. IN NO
EVENT SHALL CULLIGAN. BE LIABLE FOR ANY ANTICIPATED OR LOST PROFITS, INCIDENTAL
DAMAGES, CONSEQUENTIAL CHARGES OR OTHER LOSSES, WHETHER BASED ON BREACH OF
CONTRACT, TORTIOUS CONDUCT OR ANY OTHER THEORY, INCURRED IN CONNECTION WITH THE
PURCHASE, INSTALLATION, REPAIR OR OPERATION OF THE OPAQUE FILTER HOUSING. CULLIGAN
DOES NOT AUTHORIZE ANYONE TO ASSUME FOR IT ANY LIABILITY OR MAKE ON ITS BEHALF ANY
ADDITIONAL WARRANTIES IN CONNECTION WITH THE OPAQUE FILTER HOUSING OR ANY PART
THEREOF.
For servicing under this warranty, return any defective part to YOUR RETAILER within the five-year
period referred to above.
1
2
3
4
Customer Service
M-F 7:30 a.m – 5:00 p.m. CST
Phone: 1-800-634-1455 Fax: 1-888-749-8826
International: Phone (920) 457-9435 • Fax (920) 457-2417
e-mail: customerservice@culligan.com
Sales & Marketing Correspondence
P.O. Box 1086 • Sheboygan, WI 53082-1086
Fax (847) 291-7632
e-mail: sales-marketing@culligan.com
©2003 Culligan International Company, Printed in U.S.A. 11/03 145765 Rev C
Culligan International Company
One Culligan Parkway
Northbrook, Illinois 60062
www.culligan.com
To Next Page
Loading...
