CULLMANN CUlight FR 36C - Setting Group Units Flash Mode; Master Units Flash off; Setting the Communication Channel

4140
Slave Unit Setting
1
Long Press the < SYNC >
button for 2 seconds so that
< > is blinking. Turn the
Select Dial until the < >
is displayed on the LCD pan-
el, which means the slave
unit.
2. Setting Group Unit’s Flash Mode
1
Press the < SLAVE > Button
to choose the group from
A/B/C. Then, press the
< MODE > Button so that
the master unit can work in
OFF / TTL / M ash mode.
Choose one of them as the
ash mode of master unit.
2
Press the < MODE > Button
for 2 seconds to switch to
Multi mode.
3. Master Unit‘s Flash OFF
1
When the ash attach to
camera, enter the external
ash control on the cam-
era menu.
2
Turn off the master control
ash on the camera . The
< > icon will blink on the
CUlight FR 36C panel, and
the ash master control unit
is disabled. Select turn on
to cancel the master control
unit disabled.
4. Setting the Communication Channel
If there are other wireless ash systems nearby, you can change
the channel IDs to prevent signal interference. The channel IDs of
the master unit and the slave unit(s) must be set to the same.
1
Long press the < SLAVE >
Button for 2 seconds un-
til the channel IDs is blink-
ing. Turn the Select Dial to
choose a channel ID from
1 to 16.
2
Press the < SET > button to
conrm.
5. TTL: Fully Automatic Wireless
Flash Shooting
Autoash Shooting with One Slave Unit
1
Master Unit Setting
• Attach a CUlight FR 36C
camera ash on the cam-
era and set it as the mas-
ter unit. (Page 39)
• A/B/C can be set as TTL
mode independently.
2
Slave Unit Setting
• Set the CUlight FR 36C
that to be controlled as
the wireless slave unit.
(Page 40)
• The slave unit can be set
as A/B/C.
3
Check the communica-
tion channel
• If the master unit and slave
unit(s) are set to a different
channel, set them to the
same channel. (Page 40)
4
Position the camera and
ashes
• Position the camera and
ashes as the picture
shows. (Page 43)
5
Check the ash operation
• Press the master unit’s
Test Button< >.
• Then, the slave unit will
re. If not, adjust the slave
unit’s angle toward the
master unit and distance
from the master unit.
• The slave unit might be out of order or re an unwanted
ash due to the nearby wi routers or other 2.4G equip-
ments. If in this case, please adjust the ash’s channel or
turn off the 2.4G equipments.
FR36_BDA_Canon 171005.indd 40-41 06.10.2017 15:08:01