EasyManua.ls Logo

CULLMANN CUlight FR 36C - M: Wireless Flash Shooting with Manual Flash; Multi: Wireless Flash Shooting with Manual Flash

CULLMANN CUlight FR 36C
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4342
6. M: Wireless Flash Shooting
with Manual Flash
This describes wireless (multiple shooting) using manual ash.
You can shoot with a different ash output setting for each slave
unit (ring group). Set all parameters on the master unit.
1
Setting the ash mode
to < M >
Press the < MODE > But-
ton to set the ash to M
mode.
2
Setting ash output
Turn the Select Dial to set
the ash output of the
groups.
3
Taking the picture
Each group res at the set
ash ratio.
7. Multi: Wireless Flash Shooting
with Manual Flash
1
Set ting < Multi > strobo-
scopic ash.
Long press the < MODE >
button for 2 seconds so
that <Multi > is displayed.
Long press the < MODE >
button for 2 seconds again
to exit.
2
Setting ash output/ash
frequency/ash times.
Setting the ash out-
put/ash frequency/ash
times in the A group. Set-
ting the multi ash mode.
(see Page 38)
B and C group can only
control the ON/OFF of the
slave unit by pressing the
< MODE > Button.
Using a ash (master/slave) with a radio transmission wireless
shooting function make it easy to shoot with advanced wireless
multiple ash lighting, in the same way as TTL autoash shooting.
The basic relative position and operation range are as shown in
the picture. You can then perform wireless TTL autoash shoot-
ing just by setting the master unit to < TTL >.
Slave/Master Unit‘s Positioning and Operation Range
Autoash Shooting with One Slave Unit
• Use the supplied mini stand to position the slave unit.
• Before shooting, perform a test ash and test shooting.
• The transmission distance might be shorter depending on
the conditions such as positioning of slave units, the sur-
rounding environment and weather conditions.
Transmission distance is about 30m.
Wireless Multiple Flash Shooting
You can divide the slave units into two or three groups and per-
form TTL autoash while changing the ash ratio (factor). In ad-
dition, you can set and shoot with a different ash mode for each
ring group, for up to 3 groups.
• Auto Shooting with Two Slave Groups
• Auto Shooting with Three Slave Groups
FR36_BDA_Canon 171005.indd 42-43 06.10.2017 15:08:02

Related product manuals