CUMMINS ALLISON Universal JetScan 4166 User Manual

11
1.
Turn power
OFF
(rocker panel to
0
).
2.
Disconnect power cord from the rear of the Universal
JetScan.
3.
Lift adjustable hopper to the upright position.
4.
Remove feeder plate as shown below.
5.
Use a microfiber towel to clean the black start sensor at the
top, middle of the feeder plate, as identified at left.
6.
Use a Simple Green Safety Towel to remove dirt buildup from the upper and lower aluminum
rollers. To reach all exposed surfaces, rotate the large, black feed rollers forward (direction of
note flow).
Rotating the large, black feed rollers will rotate all other shafts and
rollers in the machine. These rollers can be rotated in either
direction by using fingers. Generally, the top of these rollers should
be rotated forward (direction of note flow), so any dirt or stray
material is moved out of the unit.
If there is heavy buildup on the aluminum rollers, remove it
with a clean, soft eraser as shown.
© 2014 Cummins-Allison Corp.

CUMMINS ALLISON Universal JetScan 4166 Specifications

General

Brand	CUMMINS ALLISON
Model	Universal JetScan 4166
Category	Scanner
Language	English