Use a Simple Green Safety Towel to clean all rubber sections
of the large, black feed rollers. Rotate the rollers.
Also clean the flat, center rubber-drive tire, as identified at
left.
8.
Use a microfiber towel or vacuum to remove any remaining
dust in the bottom stacker.
9.
Use a microfiber towel to clean the stacker-sensor lens
located in the stacker tray between the two gray stacker
wheels.
Clean the stacker mirror located directly across from the
stacker-sensor lens.
Replace feeder plate. Insert curved edge of feeder plate first.
Gently press down on feeder plate until it snaps into position.
11.
Clean exterior surfaces as necessary with a Simple Green
Safety Towel.
12.
Return hopper to the operating position.
Single-Pocket Universal JetScan
®
Note Scanner
All Models