Luggage compartment equipment
Net partition
Using the net partition
Fig.163 Net partition tted.
The purpose of the net partition is to prevent
the items in the boot from moving into the
cabin, e.g. in the event of sudden braking.
Fitting the net partition
The partition net can be tted behind the rear
seat or, depending on the features, behind the
front seats with the second row of seats low-
ered.
●
If required, remove the rear shelf
›››page248.
●
Hook the net partition to the left-hand side
roof housing ›››Fig.163
A
. Be sure to pull the
cross rod down past the upper position.
●
Hook in the net partition on the rear right-
hand side roof housing by pressing on the bar
›››Fig.163
A
.
●
Secure two hooks of the partition net to the
fastening rings of the boot ›››Fig.163
B
and
tighten the straps rmly.
To remove it proceed in reverse order.
WARNING
●
Always secure objects, even when the net
partition is properly assembled.
●
There should be nobody behind the as-
sembled partition when the vehicle is mov-
ing.
●
The attachments on the backs of the rear
seats must never be used to t the net par-
tition when the rear seat backs are in their
vertical position.
NOTICE
If the net partition is secured incorrectly or
to incorrect points, this may damage the ve-
hicle.
Luggage compartment
equipment
Fastening rings
Fig.164 In the luggage compartment:
fastening rings.
There are fastening rings ›››Fig.164 on the
front and rear of the boot to secure loose
objects and luggage with fastening belts and
cords.
To Next Page
Loading...
