Cupra ATECA 2022 - Changing a Wheel

308
Wheels and tyres
●
If there is a danger of being trapped despite
having tted the chains, it is best to disable the
traction control (TCS) in the ESC ›››page142.
Snow chains will improve braking ability as well
as traction in winter conditions.
For technical reasons, the use of snow chains
is only permitted on the following rim and tyre
combinations:
Tyres Wheel rim Chains
225/50 R18 7Jx18 VAS 45
Max. link 9
mm
225/45 R19 8Jx19 VAS 45
Other dimensions do not allow chains
Remove any central wheel trims before tting
snow chains.
WARNING
The use of unsuitable or incorrectly tted
chains could lead to serious accidents and
damage.
●
Always the appropriate snow chains.
●
Observe the tting instructions provided
by the snow chain manufacturer.
●
Never exceed the maximum permitted
speeds when driving with snow chains.
NOTICE
●
Remove the snow chains to drive on roads
without snow. Otherwise they will impair ve-
hicle handling, damage the tyres and wear
out very quickly.
●
Wheel rims may be damaged or scratched
if the chains come into direct contact with
them. CUPRA recommends the use of coated
snow chains.
Changing a wheel
Introduction
Only change a wheel yourself if you are famil-
iar with the necessary operations and safety
measures, if you have the necessary tools and
if the vehicle is parked safely.
Preliminary actions
●
Stop the vehicle on a level surface and in a
safe place, as far away from road traic as pos-
sible.
●
Apply the electronic parking brake.
●
Switch on the hazard warning lights.
●
Automatic transmission: switch on the park-
ing lock P.
●
If towing a trailer, unhitch the trailer from
your vehicle.
●
Lay out the on-board tools ›››page272 and
the wheel to be changed.
●
Follow the legal provisions of each country
(reective vest, warning triangles, light beacon,
etc.).
●
Get all occupants out of the vehicle and
keep them out of the danger zone (e.g. behind
the guard rail).
WARNING
●
Always observe the above steps and pro-
tect yourself and other road users.
●
If you change the wheel on a slope, block
the wheel on the opposite side of the car
with a stone or similar to prevent the vehicle
from moving.