Cupra BORN - Page 104

Opening and closingWindow controls
103
Note
If the window is not able to close because
it is sti or because of an obstruction,
the window will automatically open again
››› page 103. If this happens, check why the
window could not be closed before attempt-
ing to close it again.
Window anti-trap function
The roll-back function reduces the risk of in-
jury when the electric windows close.
If a window encounters resistance or an obsta-
cle when closing, it will reopen immediately
›››
.
•
Check why the window does not close.
•
Try closing the window again.
•
If the closing process is interrupted again,
the anti-trap function stops working for a few
seconds.
•
If the window still cannot be closed, it will
stop in the corresponding position. Pulling
the button again within a few seconds closes
the window without the anti-trap function
››› .
Closing the windows without the anti-trap
function
•
Try to close the window again by pulling the
button without releasing it, within a few sec-
onds. The anti-trap function will be deacti-
vated!
•
If the closing process takes longer than a
few seconds, the anti-trap function is activated
again. The window will stop again if it encoun-
ters resistance or an obstacle, and will reopen
automatically.
•
If the window will still not close, visit a speci-
alised workshop.
WARNING
Observe the safety warnings ››› in Open-
ing and closing the windows on page 102.
•
The roll-back function does not prevent
ngers or other parts of the body getting
pinched against the window frame. Risk of
accident.
Note
The anti-trap function also works when the
windows are closed with the comfort func-
tion using the vehicle key.