Cupra BORN - Page 117

Lights
116
• On roads with traic in the opposite direction
and with a central reservation barrier where
the driver can see over it e.g. lorry drivers.
•
In the event of fog, snow or heavy rain
•
In the event of dust or sand storms
•
If the windscreen is damaged in the camera's
eld of vision.
•
If the camera's eld of vision is misted up,
dirty or covered by a sticker, snow or ice.
•
If the camera is damaged or if the power
supply has been cut o.
WARNING
The convenience features of the main beam
assist should not encourage the taking of
risks. The system is not a replacement for
driver concentration.
•
You are always in control of the main beam
and adapting it to the light, visibility and traf-
c conditions.
•
It is possible that the main beam headlight
control does not recognise all driving situa-
tions and is limited under certain circumstan-
ces.
•
When the eld of vision of the camera is
dirty, covered or damaged, operation of the
main beam control may be aected. This also
applies when changes are made to the vehi-
cle lighting system, for example, if additional
headlights are installed.
NOTICE
To avoid aecting the operation of the sys-
tem, take the following points into considera-
tion:
•
Clean the eld of vision of the camera reg-
ularly and make sure it is free of snow and ice.
•
Do not cover the eld of vision of the cam-
era.
•
Check that the windscreen is not damaged
in the area of the eld of vision of the cam-
era.
Note
•
The headlight asher can be turned on and
o manually at any time with the turn signal
and main beam lever ›››
page 114
.
•
If there are objects that radiate light in the
camera's area of inuence, e.g. a portable
navigation system, this may aect the opera-
tion of the main beam assist system.
“Coming home” and “Leav-
ing home” function (exterior ori-
entation lighting)
The “Coming home” and “Leaving home”
function lights up the vehicle’s immediate sur-
roundings when getting into and out of it in the
dark.
This light is automatically controlled by a light
sensor.
Turning on the “Coming home” light
•
Unlock the car (if the automatic dipped
beam function is switched on and the light
sensor detects darkness).
Turning o the “Coming home” light
•
It turns o automatically once the lights o
delay time has elapsed.
•
OR: lock the vehicle.
•
OR: press the light control as many times as
necessary until the instrument cluster displays
the setting .
•
OR: switch on the ignition.
Turning on the “Leaving home” light
•
Switch the ignition o.
The “Leaving home” light comes on if the au-
tomatic headlight control is switched on
and the light sensor detects darkness.
The lights-o delay countdown starts when
the last door or rear lid of the vehicle is closed.
Turning o the “Leaving home” light
•
It switches o automatically after the set
lights-o delay time has elapsed.
•
EITHER: it is automatically deactivated if, 30
seconds after the function has been activated,
any vehicle door or the rear lid is still open.