• OR: press the light control as many times as
necessary until the instrument cluster displays
the setting .
•
OR: switch on the ignition.
“Coming home” and “Leaving home” set-
tings
The duration of the lights-o delay can be set
in the vehicle settings menu of the infotain-
ment system, where the function can also be
activated and deactivated ››› page 36.
Depending on the equipment, the behaviour
of the exterior lighting can be adjusted in the
infotainment system, under vehicle settings.
In the
Comfort light settings
menu you
can choose between the following two var-
iants:
•
Classic entry and exit lighting
:
The indicator lights yx and headlights turn on
and o simultaneously.
•
Dynamic entry and exit lighting
:
The indicator lights, headlights and rear light
clusters turn on and o dynamically and, if ap-
plicable, with animation.
Dynamic headlight range control
The headlight range is automatically adjusted
according to the vehicle load status when they
are switched on.
WARNING
If the dynamic headlight range control fails
or does not work properly, the headlights
could dazzle and distract other road users.
This could cause accidents and lead to seri-
ous injuries.
•
Immediately go to a specialist workshop
and have the headlight range control system
checked.
Interior lights
Instrument cluster and control
lighting
The instrument and control lighting intensity,
as well as the basic lighting intensity of the
Head-up-Display, can be set in the vehicle
settings menu of the infotainment system
››› page 36.
The set intensity automatically adapts to
changes in ambient brightness in the vehicle.
When the automatic dipped beam light
is turned on, a sensor automatically turns the
dipped beam light on or o, as well as the in-
strument and control lighting, depending on
the ambient brightness.
Interior and reading lights
Fig. 108 Detail of headliner: front interior
lighting.
Turning the interior lights on or o.
Door contact connection. The interior
lights come on automatically when you
unlock the vehicle, open a door or dis-
connect the ignition. The light goes out
a few seconds after closing all the doors,
when locking the vehicle or connecting
the ignition.
Reading light
The reading light is tactile, each lens is turned
on and o individually by pressing in the re-
spective central area. In addition, the intensity
of the light can be adjusted according to the
pressure exerted.
If you want to turn on the two lenses together
you must press the symbol
›››
Fig. 108.
To Next Page
Loading...
