Cupra BORN - Page 127

Visibility
126
Opening and closing the sunshade blind
•
Automatic function: swipe your nger for-
ward (open) or back (close) over the function
button ››› Fig. 115. Pressing the function but-
ton stops the automatic function.
•
Manual function: slide a nger across the
function button forwards (open) or backwards
(close) and hold until the blind reaches the de-
sired position.
Anti-trap function of the sunshade blind
The anti-trap function can reduce the risk of
injury when closing the sunshade blind ›››
.
If the blind encounters resistance or an obsta-
cle when closing, it will reopen immediately.
•
Check why the blind did not close.
•
Try to close the blind again.
•
If the blind still cannot be closed due to an
obstacle or resistance, it will reopen immedi-
ately. Once open, it can be closed for a short
space of time without the anti-trap function.
•
If it is still not possible to close the blind,
close it without the anti-trap function.
Closing the sunshade blind without the anti-
trap function
•
Try to close the blind again.
•
If it still cannot be closed, within 5 seconds
slide the function button backwards without
releasing it ››› Fig. 115 until the blind closes
fully. The blind closes without the interven-
tion of the anti-trap function!
•
If it is still not possible to close the blind, visit
a specialised workshop.
If the function button is released during clos-
ing, the blind opens automatically.
The button reacts dierently than expected
Moisture, dirt, grease, etc., can limit the opera-
tion of the buttons. Make sure the buttons are
always clean and dry.
WARNING
Closing the sun blind without the anti-trap
function can cause serious injury.
•
Always close the blind with care.
•
Do not allow anyone to remain in the blind
travel area, particularly when closing without
the anti-trap function.
•
The anti-trap function does not prevent
ngers or other parts of the body from be-
coming trapped against the roof frame and
injuries occurring.