Cupra BORN - Page 133

Air conditioning
132
• Automatic air recirculation is activated and
deactivated in the air conditioning settings
menu. An A will be displayed next to the Clima-
bar’s recirculation icon , indicating that the
function is active ››› page 129.
WARNING
Stuy or used air will increase fatigue and re-
duce driver concentration possibly resulting
in a serious accident.
•
Never leave the fresh air fan turned o or
use the air recirculation for long periods of
time; the air in the vehicle interior will not be
refreshed.
NOTICE
In vehicles with an air conditioner, do not
smoke when air recirculation is switched on.
The smoke may be deposited on the cooling
evaporator and on the active combination l-
ter and cause permanent unpleasant odours.
Note
When the outside temperature is very high,
briey switching on the air recirculation
mode helps to cool the vehicle interior more
quickly.
Front seat heating
The front seats have three levels of electric
heating.
Control seat heating
Press the on the Climabar
A
to drop down
the seat heating menu.
•
Press the left or right seat icon to connect
the seat heating to maximum power.
•
Press the left or right seat icon repeatedly
until the desired level is adjusted.
•
To switch o seat heating, press the corre-
sponding seat icon several times until no LED is
on.
•
You can also adjust the seat heating level by
using two ngers to press the sensor eld
1
o
2
(left or right seat).
If the ignition is switched on again in approx.
the next 10 minutes, the driver seat heating
is automatically turned on to the level set the
last time. If the passenger seat is occupied, the
heating for this seat is also switched on auto-
matically at the last set level.
If the passenger leaves his or her seat while
the seat heater and drive system are switched
on, the heating of that seat disconnects auto-
matically. The indication on the infotainment
system turns grey after approx 2 seconds. If
the passenger sits down again while the drive
system is still switched on, the seat heating
switches on again automatically.
If the heating of this seat disconnects auto-
matically, you can switch it on again manually if
necessary, even if the seat is unoccupied.
Smart Heated Seats
This is an smart function that automatically ac-
tivates and regulates the driver and front pas-
senger seat heating for greater comfort.
The seat heating for the driver's seat and front
passenger seat can be adjusted separately to
achieve fully personalised comfort.
To access the Smart Heated Seats it is nec-
essary to rst activate the CUPRA CONNECT
Gen4 personalisation service ››› page 216.
The Smart Heated Seats function requires a
period for learning usage habits. Information
about the start of the learning process is
shown in the seat heating submenu on the In-
fotainment display. Its evolution (learning) will
also be shown during this process, until it is
complete (AUTO).
Seat heating level 3 (maximum) needs to be
used to ensure that habits are learned cor-
rectly.
During the learning period, it is advisable to
use the seat heater at dierent outside tem-
peratures to achieve optimum performance of
the smart heated seats.
Once the learning period is over, the heated
seats are turned on and their temperature level
adjusted automatically.