EasyManua.ls Logo

Cupra BORN - Page 146

Cupra BORN
343 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DrivingGear selection
145
Troubleshooting
Fault in the electric drive system or the
high-voltage on-board network
The control lamp switches on yellow.
A message to this eect is displayed in the Dig-
ital Cockpit.
There is a fault in the electric drive system or
the high-voltage on-board network.
Go immediately to a specialised workshop
and request the electric drive system be
checked.
It is possible to continue driving.
The vehicle key is not recognized
A message to this eect is displayed in the Dig-
ital Cockpit.
If the vehicle key’s button battery is almost or
fully run out, the key may not be recognized.
An emergency start must be performed:
Place the vehicle key on the base of the cen-
tral armrest drawer, as close to the symbol
as possible.
Depress the brake pedal or press the igni-
tion/start button.
The ignition is switched on.
The drive system cannot be switched o
An emergency disconnection must be per-
formed:
Stop the vehicle.
Press the ignition/start button twice within a
few seconds, or press and hold it once.
The drive and ignition system switches o.
e-Sound does not work
The control lamp lights up yellow and an audio
signal sounds.
A message to this eect is displayed in the Dig-
ital Cockpit.
Contact a specialised workshop.
It is possible to continue driving.
The drive system cannot be connected
If an unauthorised vehicle key is used or there
is a fault in the system, a message to this eect
is displayed in the Digital Cockpit.
Use an authorised key.
If the fault persists, seek specialist assistance.
Gear selection
Gear selector
Fig. 119 Gear selector with the electronic
parking brake button.
The vehicle has a forward gear D/B and a re-
verse gear R.
The gear selector has a button for the elec-
tronic parking brake. To change from neutral
N to another position, switch on the ignition,
depress the brake pedal and turn the selector
in the desired direction ››› Fig. 119 (arrow):
– Permanent forward drive position
The electric drive system is in the normal
program (automatic brake energy recupera-
tion when the eco-eicient driving assistant is
switched on ››› page 141).

Other manuals for Cupra BORN

Related product manuals