EasyManua.ls Logo

Cupra BORN - Page 194

Cupra BORN
343 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Parking and manoeuvringParking aid Plus
193
A
B
C
D
with a symbol and a greyed-out graphic
segment. If necessary, the parking system
switches o the aected zone.
If the park assist is not working properly, a con-
tinuous audio signal sounds for a few seconds
when it is switched on. If applicable, a message
to this eect is displayed on the instrument
cluster screen
Check if one of the causes indicated above
has occurred.
Once the source of the problem has been
eliminated, the system may be reconnected.
If the problem persists, consult a specialised
workshop.
Parking aid Plus
Description
Fig. 148 Parking aid view on the
Infotainment system display.
Parking aid plus assists the driver by giving
visual and audio warnings about obstacles de-
tected in front of and behind the vehicle.
The bumpers are tted with sensors. When
an obstacle is detected, it is indicated by au-
dible signals and in the Infotainment system
››› Fig. 148.
When moving close to an obstacle, it is possi-
ble to know if the obstacle is in front of the
vehicle or behind it according to the sound
frequency.
The approximate measurement range of the
sensors is:
1.20 m
0.90 m
1.60 m
0.90 m
As you approach the obstacle, the frequency
of the audible signals will increase. The signal
will sound continuously at around 0.30 m: Stop
the vehicle!
If the separation is maintained, the volume of
the warning starts to decrease after about 2.5
seconds and for the next 2.5 seconds it is fades
away until disappearing completely.
Error messages
If a an error or fault message is displayed on
the instrument cluster in Park Assist, there is a
fault.
If the fault doesn't disappear before discon-
necting the ignition, it will not be indicated
next time the parking aid is connected.
If a rear sensor is faulty, only the obstacles in
the areas
A
and
B
››› Fig. 148 are displayed.
If a front sensor is faulty, only the obstacles in
the areas
C
and
D
are displayed. The symbol
is displayed.
We recommend taking the vehicle to a special-
ised workshop to have the fault repaired.
WARNING
Always pay attention, by looking directly,
to traic and the area around the vehicle.
Assistance systems are not a replacement for
driver awareness. Responsibility always lies
with the driver.
The sensors have blind spots in which ob-
stacles and people are not detected. Pay spe-
cial attention to children and animals.
Always keep visual control of the surround-
ings: use the mirrors for additional help.

Other manuals for Cupra BORN

Related product manuals