Cupra BORN - Page 257

Infotainment system
256
Active
Passive
• The vehicle must be stopped or someone
must be detected in the front passenger seat
to perform the pairing.
Pair a mobile phone device suitable for tel-
ephony with the infotainment system to use
the telephone interface functions. On the rst
connection, the mobile phone device is paired
with the infotainment system. Doing so saves a
user prole ››› page 256, User proles.
The pairing can take a few minutes. The func-
tions available depend on the mobile phone
device used and its operating system.
Pair a mobile phone device
1.
Open the list of available Bluetooth® devi-
ces on the mobile phone device and select
the name of the infotainment system.
2.
Please note and, if necessary, conrm
the messages that appear on the mobile
phone device and on the infotainment
system. If the pairing was successful, the
phone data is saved in the user prole.
3.
Optional: conrm the data transfer mes-
sage on the mobile phone device.
Active and passive connection
To use the functions of the telephone inter-
face, there must be at least one mobile phone
device connected to the infotainment system.
If there are several mobile phone devices con-
nected to the infotainment system, you can
switch between active and passive connec-
tions. To use the telephone interface with the
desired mobile phone device, establish the ac-
tive connection with the infotainment system.
Dierence between connection types
The mobile phone device is paired
and connected. The functions of the tel-
ephone interface are performed with the
data of said mobile phone device.
The mobile phone device is paired
and connected. Calls can be managed but
the phone book, messages or other func-
tions will not be active.
Paired mobile phone devices are stored in the
infotainment system, even if they are not cur-
rently connected.
Connect a mobile phone device
Requirement: the mobile phone device is
paired with the infotainment system.
•
Bluetooth® is activated on the mobile phone
device.
Establish an active connection
Requirement: several mobile phone devices
are connected to the infotainment system at
the same time.
•
Select the desired mobile phone device from
the drop-down menu. All other mobile phone
devices are automatically in the passive con-
nection.
User
proles
For each of the paired mobile phone devices
an individual user prole is automatically cre-
ated. In the user prole, data from the mobile
phone device is stored, for example, contact
details or settings. A maximum of four user
proles can be saved in the infotainment sys-
tem at the same time.
WARNING
If you perform the pairing while driving, it
could cause an accident or injury.
•
Perform pairing only with the vehicle at a
standstill.
Note
•
While the infotainment system is in the
Known mobile phones menu, the wireless
charging function is disabled. When you exit
this menu, the wireless charging function is
activated again.
Basic and Comfort Telephony
Depending on the equipment, two types of tel-
ephone interface can be used:
•
Basic telephone interface.
•
Comfort telephone interface.