Cupra BORN - Page 307

Wheels and tyres
306
1
2
3
4
5
6
7
8
9
10
11
WARNING
A tyre lled with sealant does not have the
same performance properties as a conven-
tional tyre.
•
Never drive faster than 80 km/h (50 mph).
•
Avoid heavy acceleration, hard braking and
fast cornering.
•
Drive for only 10 minutes at a maximum
speed of 80 km/h (50 mph) and then check
the tyre.
For the sake of the environment
Dispose of used or expired sealant observing
any legal requirements.
Note
You can purchase a new bottle of tyre seal-
ant in specialised CUPRA dealers or any SEAT
dealership.
Note
Take into account the separate instruction
manual provided by the tyre mobility system
manufacturer.
Anti-puncture kit contents
Fig. 204 Standard display: contents of the
anti-puncture kit.
The anti-puncture kit is located underneath
the oor covering in the luggage compart-
ment. Includes the following components
›››
Fig. 204:
Valve insert remover
A sticker to be adhered to the instrument
cluster, within the driver's visual eld, to
remind that the maximum advisable speed
“max. 80 km/h” or “max. 50 mph”
Filler tube with cap
Air compressor (depending on the version,
the model may vary).
ON/OFF switch
Air bleed screw (it can also be integrated in
the inator tube).
Warning provided by tyre pressure moni-
toring system (it can also be integrated in
the inator tube).
Tube for inating tyres
12 volt connector
Bottle of sealant
Spare tyre valve
The valve insert remover
1
has a gap at the
lower end for a valve insert. The valve insert
can only be screwed or unscrewed in this way.
This also applies to its replacement part
11
.
Sealing and inating a tyre
Sealing the tyre
•
Unscrew the tyre valve cap and insert. Use
the device
›››
Fig. 204
1
to remove the valve
cap. Place it on a clean surface.
•
Shake the tyre sealant bottle vigorously
››› Fig. 204
10
.
•
Screw the tyre ination hose ››› Fig. 204
3
into the tyre sealant bottle. The bottle's seal
will break automatically.
•
Remove the ller cap
›››
Fig. 204
3
and
screw the open end of the tube into the tyre
valve.
•
With the bottle upside down, empty all of
the contents into the tyre.