Current Solutions InTENSity Twin Stim III User Manual (English)

Questions and Answers:

J
Jamie CarterJul 27, 2025
What to do if my Current Solutions InTENSity Twin Stim III has intermittent output?
- B
  bowmanjohnJul 27, 2025
  If you experience intermittent output with your Current Solutions Fitness Equipment, first ensure the lead wire connection is secure. If the issue persists, decrease the intensity and rotate the lead wires in the socket by 90 degrees. If it is still intermittent, replace the lead wire. If the problem continues after replacing the lead wire, a component may have failed, and you should contact the repair department. Also, some programs will seem intermittent; this is expected.
W
wrightthomasAug 2, 2025
Why is the stimulation weak on my Current Solutions Fitness Equipment?
- W
  wbrownAug 3, 2025
  Weak stimulation on your Current Solutions Fitness Equipment can be due to several factors. The electrodes or lead wires may be dried out or contaminated, in this case you should replace and reconnect them. The placement of lead wires can also affect stimulation, so replace them if needed. Also, old, worn, or damaged electrodes or lead wires can cause weak stimulation, so replace them as well.
C
Carla MarksAug 8, 2025
How to fix Current Solutions InTENSity Twin Stim III when the display fails to light up?
- A
  Andrew WongAug 8, 2025
  If the display on your Current Solutions Fitness Equipment fails to light up, it might be due to battery contact failure. Try using fresh batteries and make sure they are inserted correctly. Check that all contacts are in place.
S
Scott ChurchAug 14, 2025
What to do if stimulation is uncomfortable with Current Solutions Fitness Equipment?
- M
  Matthew WoodsAug 14, 2025
  If the stimulation from your Current Solutions Fitness Equipment is uncomfortable, decrease the intensity. You may also need to reposition the electrodes or replace them. Consider replacing the electrodes with ones that have an active area no less than 1.5” X 1.5”.
L
Lauren RobbinsAug 20, 2025
Why is the stimulation ineffective on my Current Solutions Fitness Equipment?
- K
  Kevin SchultzAug 20, 2025
  Ineffective stimulation from your Current Solutions Fitness Equipment can be caused by improper electrode and applicator placement. Reposition the electrode and applicator. Contact clinician.

Current Solutions InTENSity Twin Stim III Specifications

General

Channels	2
Display	LCD
Electrode Compatibility	Standard electrodes
Type	TENS Unit
Timer	up to 60 minutes
Waveform	Biphasic
Power Source	Battery
Pulse Rate	2 to 150 Hz
Pulse Width	50 to 300 microseconds
Modes	TENS (Normal, Burst, Modulation, SD1, SD2), EMS (Constant, Synchronous, Alternate, Delay, Width Modulation, Frequency Modulation), IF (Constant IF 4000Hz, Constant IF 4250Hz, Alternate IF 4000Hz, Alternate IF 4250Hz), Microcurrent (Constant, Pulsed)
Intensity Levels	Adjustable 0-100mA in 1mA increments