Curt Manufacturing 13287 - Installation Walkthrough; Step 1: Remove Factory Tow Loop; Step 2: Fishwire Installation; Step 3: Raise Hitch into Position

INSTALLATION WALKTHROUGH:
For more information log onto www.curtmfg.com, & for helpful towing tips log onto www.hitchinfo.com
Parts List
DESCRIPTIONPART NUMBERQTYITEM
HEX BOLT
M12-1.75 x 35mm31
CONICAL TOOTHED WASHER1/232
CARRIAGE BOLT1/2-13 x 1 1/2, GR833
HEX FLANGE NUTHFN 1213, GR8
34
1/2" FISHWIRE1_2 FISHWIRE2
5
.250 x 1.00 x 3.00" SQUARE HOLE SPACERCM-SP636
DRIVER SIDE
FRAME RAIL
PASSENGER SIDE
FRAME RAIL
EXISTING WELDNUTS
EXISTING HOLES
3
6
4
5
2
1
1. If equipped, remove factory tow loop from driver side by
removing (6) M12 fasteners with a 15mm socket.
2. Fishwire (3) 1/2" x 1 1/2" carriage bolts and (3) CM-SP6
spacers into the passenger side mounting holes as shown
below.
3. Raise hitch into position and install remaining fasteners
as shown in the diagram to the left.
4. Torque all 12mm fasteners to 79 lb-ft and all 1/2"
fasteners to 110 lb-ft.