Curtis enAble 40 - Programmable Parameters

19
Curtis enAble
®
40 Manual, Rev. E
5 — PROGRAMMABLE PARAMETERS
5
PROGRAMMABLE PARAMETERS
The enAble
®
40 Powerchair Control System has a number of parameters that
can be programmed using a Curtis 1313 handheld programmer or Curtis 1314
PC Programming Station. The programmable parameters allow the vehicle’s
performance to be customized to fit the needs of specific applications.
For information on programmer operation, see Appendix C.
For information on how to use the parameters to optimize chair perfor
-
mance, see Section 7: Tuning Guide.
The programmable parameters are grouped hierarchically into these menus:
PARAMETERS MENU
—Configuration
...............................p. 20
—
MyChair ........................................p. 20
—Profile 1
—Drive ........................................p. 21
—Steer ........................................p. 22
—Profile 2
(same parameters as Profile 1)
—Handcontrols ...............................p. 24
—Speed Mode ............................p. 25
—Joystick ....................................p. 26
—Sound & Display .....................p. 27
—Handcontrol Inhibit ..................p. 27
—Seat ...............................................p. 28
—Lights ............................................p. 29
—Motor Controller
—Current Limits ..........................p. 29
—Multi-Function Inputs
—Input 1 .............................p. 30
—Input 2 .............................p. 31
—Input 3 .............................p. 32
—Compensation .........................p. 33
—Motors & Brakes .........................p. 34
—Battery .........................................p. 35