22
User manual Curtis G3 Series Alpha
Operation | Brewing
3.3 Brewing
Burn hazard/scalding hazard
• To avoid scalding, avoid splashing.
Keep body parts clear of the brewer during
brewing. Do not remove the brew basket
while “Brewing” appears on the display.
Note
• The G3 alpha brewer is factory preset for
optimal performance.
The brewer should be ON. Confi rm this at the rear
toggle switch. “Ready to brew” should be on the
display.
Center an empty decanter under the brew basket.
Insert a clan paper fi lter into the brew basket. Fill
with the proper amount of ground coffee. Level the
coffee in the fi lter.
Slide the fi lled brew basket into the brew rails under
the control panel. Slide it all the way back until it
stops.
Press the brew button. Brewing will begin
immediately.
The brewer will brew coffee based on the settings
programmed into the universal control module (UCM).
WARNING
NOTE
Change settings
Programming guide
page 25
To Next Page
Loading...
