41
User manual Curtis G3 Series Alpha
Troubleshooting guide | Troubleshooting Guidelines
Water Not Hot Enough
If the water heats, but is not hot enough, fi rst check
for the correct temperature setting on the control
panel. Reprogram as necessary.
Dispenser Overfl ows During Brewing
Make sure the dispenser is empty before starting the
brew cycle. If not, empty it before brewing.
No Power - Display Not Lit
On brewers with a power plug, make sure it is
connected to the power receptacle.
Make sure that the main power toggle switch on the
back panel is turned ON.
Water Tank Does Not Fill
• No water or low water in the tank can
cause the tank to overheat, resulting in the
thermostat reset switch opening. If after
correcting a tank fi ll problem there is no
power to the control panel, push the reset
switch button to reset.
Check to make sure the water supply is turned on.
Check for a clogged water supply line, water fi lter or
plugged inlet valve.
IMPORTANT
Programming guide
page 25
To Next Page
Loading...
Need help?
General
