Curtis G4 Omega Series - Ci15

Cleaning the Container (cont.)
8 Disassemble the faucet - Unscrew the handle/
bonnet assembly from the top of the faucet and
remove it. Inspect the seat cup for wear. Replace
the seat cup if it is damaged.
Unscrew the two screws from the base of the
gauge glass shield and remove the shield.
Carefully lift the gauge glass tube from the silicone
cup. Inspect the glass tube for cracks or chips. If
broken, replace the glass with a new one.
9 Air Dry - Turn the container and lid upside down
and allow to air dry.
Cleaning the Faucet Parts, Lid and Gauge Glass
10 Wash - Wash the faucet parts and the gauge
glass and silicone parts in the detergent solution.
Clean the inside of the gauge glass with a gauge
brush soaked with detergent solution.
11 Rinse - Thoroughly rinse all parts with clean,
warm water.
 Sanitize - After rinsing, place all faucet and
gauge parts in a sink to be sanitized. Immerse
them in One-Pro cleaner mixed at a ratio of 1 oz.
HQFSHBM-PGIPUXBUFS¡'¡$
NJO"MMPXUIFQBSUTUPTPBLGPSNJOVUFT
13 Air Dry - Remove the faucet and gauge parts
from the sanitizer, rinse thoroughly and allow them
to air dry.
14 Reassemble - When dry, reassemble the handle/
bonnet. Hand tighten the handle/bonnet onto
the top of the faucet assembly, reinstall the site
gauge and cover. If replacing a broken gauge
glass, carefully remove any traces of glass from
the silicone parts before inserting the new gauge
glass tube. Reinstall the lid.
WASH
RINSE
SANITIZE
CLEANING INSTRUCTIONS CI15
("--0/5)&3."-%*41&/4&3$-&"/*/(*/4536$5*0/4ø A
Gauge glass
shield
)DXFHW
Assembly
Silicone
cup
Glass
WXEH
6HDW
cup
Handle
%RQQHW
Top
cap