Curtis G4 Omega Series - Oi30

OPERATING INSTRUCTIONS OI30
Brewing Instructions
The G4 Omega Brewer is factory preset for optimal performance.
0.&("01&3"5*/(*/4536$5*0/4ø /$
2 Center an empty dispenser
under the brew basket.
3 *OTFSUBDMFBOQBQFSmMUFS
into the brew basket. Fill with
the proper amount of ground
coffee. Level the coffee in the
mMUFS
4 4MJEFUIFmMMFECSFXCBTLFU
into the brew rails under the
control panel. Slide it all the
way back until it stops.
5 )PMEZPVSmOHFSPOUIF
appropriate brew icon. As
soon as you hear the click
of the brew valve, lift your
mOHFS#SFXJOHXJMMCFHJO
The brewer will brew coffee based on the settings programmed into the universal control module (UCM). To
change the settings, see the PROGRAMMING GUIDE section.
 The brewer should be ON.
$POmSNUIJTBUUIFQPXFS
switch on the side. “Ready
to brew” should be on the
display. If the brewer is
connected to an inter-lock
grinder, the grinder should
be on. When inter-lock
connection is made, grind
coffee at this time.
WARNING - TO AVOID SCALDING, AVOID SPLASHING. Keep body parts clear of the brewer during
CSFXJOH%POPUSFNPWFUIFCSFXCBTLFUXIJMFi#SFXJOHwBQQFBSTPOUIFEJTQMBZ
6 If a keypad appears on
the display, the brew code
feature is enabled (default
is off). Brewing will start
immediately after you enter
the brew code. See the
PROGRAMMING GUIDE to
set up/disable the brew code.
Power switch