Curtis G4TP2S10A3500 User Manual

INSTALLATION INSTRUCTIONS II9
Brewers With A Cord Set Attached
11 Connect the power cord to the appropriate type of
electrical outlet.
Power Up the Brewer
12 Turn on the water supply valve.
13 Make sure that the circuit breaker supplying power to
the unit is on.
14 Turn the toggle switch on the back of the brewer to the
0/QPTJUJPO5IFXBUFSUBOLXJMMTUBSUUPmMM8IJMFUIF
UBOLJTmMMJOHJOTQFDUUIFXBUFSTVQQMZMJOFGPSMFBLT
15 Go to the PROGRAMMING GUIDE section and
program the brewer for the correct model and batch
number.
16 8IFOUIFXBUFSMFWFMJOUIFUBOLSJTFTUPUIFDPSSFDU
volume, the heating elements will turn on automatically.
Depending on the incoming water temperature and
UIFFMFDUSJDBMTQFDJmDBUJPOTUIFXBUFSUBOLUZQJDBMMZ
requires 20 to 30 minutes to reach the factory set
PQFSBUJOHUFNQFSBUVSF8IFOUIFXBUFSIBTIFBUFE
“Ready to Brew” should be on the display.
17 #FGPSFCSFXJOHGPSUIFmSTUUJNFEJTQFOTFPVODFTPG
hot water through the hot water faucet to help purge air
from the tubing inside the brewer.
18 Brew a cycle of at least 12 ounces, to purge any
remaining air from the tubing. See OPERATING
INSTRUCTIONS. During the initial brew cycle and
XIFOFWFSUIFmMUFSJTSFQMBDFEZPVNBZIFBSUIF
TPVOETPGBJSCFJOHQVSHFEGSPNUIFmMUFSUVCJOHBOE
water tank.
Connect the Brewer Wiring (cont.)
WARNING: Connect the power cord to the
appropriate type and size electrical outlet. If the
electrical outlet is not compatible with the power
cord, have it upgraded by a licensed electrician. Do
not modify the power plug. Do not use an extension
cord. Do not use a power cord/plug that is damaged.
IMPORTANT: 8IFOPQFSBUJOHUIFCSFXFSBU
higher elevations, reduce the operating
temperature by 2°F for each 1000 feet of
elevation. See PROGRAMMING GUIDE.
G4 THERMOPRO, INSTALLATION INSTRUCTIONS 011917NC
Back of brewer

Curtis G4TP2S10A3500 Specifications

General

Brand	Curtis
Model	G4TP2S10A3500
Category	Coffee Maker
Language	English