5
1. Brewer should be ON (Confirm Rear Toggle Switch is on, then Press ON/OFF Button)
2. Place an empty Satellite on the brewer deck.
3. Place Filter and Ground Coffee in Brew Cone. Position into brew rails.
4. Press the desired BREW BUTTON. Brewing will begin immediately. (If Recovery Light is
ON, Brew Light will blink and brewing will begin when the correct
temperature is reached.)
WARNING: To avoid
scalding, do NOT
remove brew cone
while brew indicator
light is flashing.
IMPORTANT: To STOP a brew cycle on either side, push and hold the Brew Button for three [3]
seconds. This will cancel the individual brew cycle. To stop all brewing (both sides), PUSH the ON/OFF button.
BREWING
INSTRUCTIONS
To Next Page
Loading...
