8
BREW VOLUME – Factory Pre-Set to Brewer Requirements
You can quickly change the brew volume of your ADS System by following these steps.
Determine Bypass setting BEFORE adjusting brew volume. (See Page 8). Volume should be set to NO greater
than 1” BELOW the TOP Lip of the satellite or server. Less than 1” below the top lip can cause an overflow condi-
tion.
BREW CYCLE COUNTER
This function allows you to see exactly how many brew cycles occurred on the system. It’s ideal for pre-
ventative maintenance programs (i.e., changing of water filters, etc.) and determining
profitability. To view the number of cycles follow these steps:
CYCLE EXAMPLE
SETS PATTERN COUNT FACTOR TOTAL
1st 4 1’s 4
2nd 2 10’s 20
3rd 0 100’s 0
4th 1 1,000’s 1,000
5th 0 10,000’s 0
TOTAL BREWS 1,024
SLEEP MODE – Factory Pre-Set to Disabled
Your Curtis ADS System features an energy saving SLEEP Mode. This function conserves energy by auto-
matically placing the unit to sleep (reducing heating tank temperature to 140°F) when it is idle for more than
2 hours. When using SLEEP Mode normal expansion and contraction of water due to changes in tempera-
ture may cause your FIRST Brew after overnight recovery to be slightly greater. Subsequent brew cycles
during regular operation will NOT experience additional volume.
To recover, simply press any BREW (or GRIND Selection if InterLocked) or ON/OFF button. (NOTE:
When recovering by pressing BREW the green brew light will begin blinking, be sure to place the Brew
Cone and Satellite in position. Once brew temperature is reached the brew cycle will automatically start.)
Recovery is indicated by a yellow light on the membrane. In a few minutes the tank will reach brew
temperature setting as indicated by the READY-TO-BREW light. Recovering from SLEEP is faster and
more efficient than heating from an OFF position.
ENTERING THE PROGRAM MODE
For ALL Functions you must first enter the programming mode.
• Turn OFF the power from the Control Panel by pressing .
• Press and HOLD and Press and RELEASE .
MODE #1
• Continue HOLDING until STARTS blinking; RELEASE.
ON/OFF
ON/OFF
BREW
BREW
READY TO BREW
CHANGE BREW VOLUME – Factory Preset to Brewer Requirements
Enter the Programming Mode #1: (CAUTION: Be sure to have brew cone and vessel in position.)
• Press and HOLD until hot water starts running; then RELEASE.
• When desired volume is reached, press again to stop the flow. To set and exit press .
BREW
BREW
ON/OFF
TO ACCESS PREVENTATIVE MAINTENANCE BREW CYCLE COUNTER
Enter the Programming Mode #2:
• will now start a pattern of LONG and SHORT blinks.
This pattern identifies the number of brew cycles. SHORT blinks indicate the brew number
from 1 to 9. LONG blinks separate 1's, 10's 1,000's and 10,000's.
READY TO BREW
ENTERING THE PROGRAM MODE
For ALL Functions you must first enter the programming mode.
• Turn OFF the power from the Control Panel by pressing .
• Press and HOLD and Press and RELEASE .
MODE #2
• Continue HOLDING until STOPS blinking; RELEASE.
ON/OFF
ON/OFF
BREW
BREW
READY TO BREW
SLEEP MODE – Factory Preset to DISABLED
To ENABLE Sleep Mode:
• UNIT MUST BE ON. Press and HOLD until
Sleep Mode is now ENABLED.
To DISABLE Sleep Mode:
• UNIT MUST BE ON. Press and HOLD until
Sleep Mode is now DISABLED.
ON/OFF
ON/OFF
ON/OFF
ON/OFF
light turns OFF; Press again.
light turns ON; Press again.
To Next Page
Loading...
