CAB INSTALLATION
18 of 35
Fig. 7.2 (Connect Dynamo Wiring Harness)
Fig. 7.3 (Cable Tie Hoses)
Fig. 7.5 (P-Clamp Wire Harness to ROPS Bracket)
Cable
Tie
P-Clamps
Fig. 7.6 (Secure Wire Harness)
Cable
Ties
7.2 See fig. 7.2. Connect the dynamo wiring harness
to the dynamo.
7.3 See fig. 7.3. Secure both hoses to the vehicle
frame using a cable tie as shown. Ensure that the
hoses will not contact any sharp edges.
Hardware Used Qty
Cable Tie 1
7.4. Route the regulator power harness forward over
the ROPS tube but below the flat area that the
hood seals on when it is closed.
Avoid any moving parts.
Continue running the harness under the seat and
around to the other side. Route it over the right
side of the ROPS, again below the flat area that
the hood seals on when it is closed.
7.5 See fig. 7.5. Cut the cable ties securing the wiring
harness and attach the harness to the lower
ROPS brackets with p-clamps as shown.
Hardware Used Qty
1/4-20x1” Button Head Bolt 2
1/4-20 Flange Nut 2
3/4” P-Clamp 2
7.6 See fig. 7.6. Using two cable ties, secure the wire
harness to the compressor lines just below the
regulator connectors and another where
compressor lines bend to go to the compressor.
Ensure that the wire harness will not contact any
sharp edges. Make sure hood closes without
hitting the wire harness.
Hardware Used Qty
Cable Ties 2
To Next Page
Loading...