14
GB
SETUP
1. Go into SETUP mode by pressing Key
FEED and Key PRINT and turn power on at
the same time.
2. The printer should print all list of the
parameters:
- CR disabled* or CR enabled
- Enabled* or disabled.
- Normal* or Reverse.
- ESC/POS *
.
- No Addressable* or Addressable
- 57600, 38400,19200 *,9600,
4800, 2400, 1200.
- 7, 8 bits/chr *
- 7, 8 bits/chr *.
- XON/XOFF* or Hardware.
- Normal* or Low.
- Disabled* or enabled
- Normal*, Dark, Light.
Notes: The parameters indicated with a *
symbol are the default values.
Printer emulation:
Protocol :
Baud Rate :
Data length : .
Parity :
Handshaking :
Speed:
Offline :
Print density:
TM
Autofeed:
Panel keys:
Print mode:
,CUSTOM
DPT24, CUSTOM DPT42 or CBM
iDP560RS
With “ESC/POS “ :
““
““
ä
A=32 / B=42 col. * or
A=42 / B=56 col.
18x24* 24 col. o 11x24
40 col.
Font A* o Font B.
Chars / line:
With CBM iDP560RS :
Font dimens :
With CUSTOM DPTxx :
Font type :
(1)
(1)
(1)
(1)
(1)
(1)(2)
(1)
(2)
NOTE:
NOTE:
Parameter valid only on serial printer.
Using this parameter, it is possible to
select whether the Busy signal is activated
when the printer is both in Off Line status
and the buffer is full, or only if the reception
buffer is full.
To Next Page
Loading...
