Need help?Do you have a question about the Custom Audio Electronics PLUS4 and is the answer not in the manual?
Instructions for unpacking the device and checking its contents.
Identifies external components of the PLUS4 STD model with numbered labels.
Identifies internal components of the device with numbered labels.
Details about the information found on the device's product label.
Illustrates the functions of the FEED key based on the device's operating state.
Explains the meaning of status LED signals and their corresponding device status.
Instructions on how to install the device using the 'Easylock' fastening system.
Shows possible connection options for the device via USB and serial ports.
Details the pin configurations for the power supply and mini USB interface.
Instructions for setting the serial port configuration for the PLUS4 STD model.
Steps to set the parallel port configuration for the PLUS4 9-42 V model.
Information on obtaining and installing drivers and SDK for various operating systems.
Step-by-step guide on how to open the front cover of the device.
Instructions for adjusting the paper width to different sizes using plastic guides.
Procedure for inserting a new paper roll into the device.
Steps to enter configuration mode and print a setup report using device keys.
Instructions for configuring device parameters using the 'PrinterSet' software tool.
How to check the printhead operating status and identify damaged dots from the setup report.
Details on printer status indicators obtained from the configuration print-out.
Details on configuring serial and USB communication parameters like baud rate, parity, and handshaking.
Configuration options for printer emulation, print mode, character sets, and font selection.
Explanation of the hexadecimal dump function for diagnosing received characters.
Recommended schedule for cleaning device components to maintain print quality and lifespan.
Detailed instructions for cleaning the device's sensors and paper compartment using compressed air.
Procedure for upgrading the device's firmware using the 'PrinterSet' software tool.
Details on sensors, emulations, drivers, interfaces, memory, and printer resolution.
Specifications related to character sets, density, columns, speed, and character dimensions.
Physical dimensions and weight for the PLUS4 STD model.
Dimensions of optional power supply units and their associated cables.
List of available character sets and coding tables for CUSTOM/POS emulation.
General| Brand | Custom Audio Electronics |
|---|---|
| Model | PLUS4 |
| Category | Printer |
| Language | English |
To Next Page