6.6 Operation parameters
The parameters marked with the symbol
D
are the default values.
PRINTER EMULATION Available emulations for the device:
CUSTOM/POS
D
SEIKO
CUSTOM TPT
APS
PRINT MODE Printing mode:
Normal
D
= enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
AUTOFEED Setting of the Carriage Return character:
CR disabled = Carriage Return disabled
CR enabled
D
= Carriage Return enabled
CHARS / INCH Font selection:
A = 11 cpi, B = 15 cpi
A = 15 cpi, B = 20 cpi
A = 20 cpi, B = 15 cpi
D
CPI = Characters Per Inch
CODE TABLE [num]
See the
paragraph 8.5-
tion numbers set with this parameter.
The character tables set with this parameter are the same set with the command 0x1B
0x74 (refer to the Commands Manual of the device).
setting of two digits for the tens and the units:
CODE TABLE [num x 10]
Setting the digit for tens:
0
D
2 4
1 3 5
CODE TABLE [num x 1]
Setting the digit for units:
0
D
2 4 6 8
1 3 5 7 9
CHINESE FONT Setting of the font:
International
D
Chinese GB18030
Korean CP949
53
To Next Page
Loading...
Need help?
General
