7.2 Cleaning
For periodic cleaning of the printer, see the instructions below.
Sensors Paper compartment
Clean the device sensor
by using compressed air.
Remove any scraps of paper and the
accumulated paper dust into the paper compartment
by using compressed air.
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
ATTENTION:
Do not use alcohol, solvents, or hard brushes.
Do not let water or other liquids get inside the device.
ON
Alcohol, solvent
1
2
1
2
Disconnect the power supply cable and open
the front cover of the device
(see paragraph 5.2).
Disconnect the power supply cable and open
the front cover of the device
(see paragraph 5.2).
58
To Next Page
Loading...
