SUB+’W’+nL+nH+kL+kH
Function WRITE rule line data
Code
ASCII SUB
Hex 1A
Decimal26
nL
nL
nL
nH
nH
nH
kL
kL
kL
kH
kH
kH
Range
0≤nL+nH×256≤640、(0≤nL≤255, 0≤nH≤3)
0≤kL+kH×256≤640、(0≤kL≤255, 0≤kH≤3)
Description Writes 1 from nL+nH×256 to kL+kH×256 on the selected rule line.
CAUTION
It is ignored if the defined range is exceeded.
Once written, the data is preserved without being erased until the clear rule
lines command is received or the power is turned off.
SUB+’C’
Function Clears rule line data.
Code
ASCII SUB C
Hex 1A 43h
Decimal26 67
Description All selected rule lines are cleared to 0.
CAUTION
To speed up processing, rule line print ON/OFF is used for printing/non-
printing of rule lines written once, and this level=>Command is used to re-
write rule line data.
SUB+’O’
Function
Rule line ON
Code
ASCII SUB O
Hex 1A 4Fh
Decimal26 79
Description
Rule lines are set to Valild(ON). When it is enabled, it is written once and the
selected rule lines are printed along with the character.
To Next Page
Loading...
