[Menu]
1.Baud rate
2.Parity
3.
Flow
control
4.
Hex
Dump
Mode
5.
Print Density
6.
Auto
Melody
7.
Cut
Mode
8.
Auto
Buzzer
9.
Print Speed
Select and then Enter...
Enter
:
Press the feed button once for
more
than
1second.
Select: Press the feed button many times
less
than
1second
as
menu
number.
E
x
i
t
:
Turn power
off then
on
.
5 PRINTER FUNCTION SETTING
There are two ways to set the printer's functions such as serial communication conditions,
Ethernet, black mark, etc., which are: a manual setting method in which the printer itself is
changed, and a method using tools such as a memory switch program that connects to a PC. For
the direct communication method through the Window Driver, refer to the separate manual
attached with the setting program on our website.
1 Setting Manually
1)
If the power is turned on while holding the FEED button for more than 2 seconds, the ERROR
light turns off and then on and off repeatedly, and the items for which settings can be adjusted
are printed as follows.
2)
Item change and specification are determined by the length of time that the FEED button is
pressed. Pressing the FEED button for less than 1 second will change to the next item. For
example, if you want to adjust the print density, press the FEED button 5 times shortly to change
the item to “5. Print Density”.
After that, if you press and hold the FEED button for more than 1 second, the item is specified
and the current setting value is output.
To Next Page
Loading...
