Customatic SQUIRE - Installation Guide

6
NOTE: For safety reasons, lifting of the adjustable bed frame must always be performed by two
(2) people; and the unit should always be on a flat surface before opening.
Installation Guide
Setting up your adjustable bed frame
1
2
Lift the bed frame unit out of the shipping carton carefully,
and put it on a flat floor with the top side facing downward.
Remove all accessory boxes and cut the orange ties from
inside the bed frame.
FOR TWIN, TXL, SQ, SCK, FULL, FXL, AND QN MODELS
FOR KING AND CAL KING MODELS
1
2
4
Lift the two separate sections of the bed frame out of the
shipping carton carefully, and put them on a flat floor with
the top side facing downward.
Remove all accessory boxes and cut the orange ties from
inside the bed frame.
Move the head and foot sections of the bed together. Make
sure the bars and frames are properly aligned.
To connect the head and foot sections, lift and place the foot
section cleats (A) over the frame stern peg (B) on the head
section. Insert B into A.
Insert the inner steel pin (C) into the cleat hole to ensure
stable assembly.
Repeat steps 4 and 5 on the other side of the frame.
3
5
6