Page 22
4.1 General operational description
F
LOW OF OPERATIONS
The normal workflow of the CLAVAESTACAS JC300 may be divided into the
following sequence of steps:
4.2 Driving posts
S
UITABILITY OF THE POSTS
Please make sure the diameter and length of the posts are within the thresholds
detailed in this manual.
Make sure that the tip of the post presents no cracks, breaks or deficiencies.
Verify that the side to be inserted in the machine and the post itself are neither
cracked nor chipped.
Should the post present deficiencies, do not use.
Insert the flat tip of the post in the post driver’s sheath until the stopping point.
Pivot the set over the post’s tip.
4.3 Starting the engine
The machine must be attached to the motor and in a vertical position.
Check that there is fuel in the machine’s tank. If necessary, replenish with
gasoline, but always with the motor off.
Hold the left handle with the left hand and lightly squeeze the throttle trigger.
Pull the recoil starter that acts directly on the engine’s crankshaft with the right
hand.
If the engine does not start the first time, repeat the operation until it does, without
engaging the throttle trigger. If it does not start, please check the spark plug for a
spark. If necessary, replace the spark plug for another as per the manufacturer’s
recommendations.
To Next Page
Loading...