CYBEX gold ATON G - Page 44

44
Installing and Removing the Infant Car Seat
Installing the Infant Car Seat Only Using Lap/Shoulder Belts
3. Lift Shoulder Belt over Handle and
around Infant Car Seat. Slide Shoulder
Belt into the rear blue Shoulder Belt
Guide AA.
4. Lock your vehicle Lap/Shoulder Belt.
Refer to your vehicle Owner's Manual
for how your vehicle Lap and Shoulder
Belt locks.
In many vehicles, you can switch the
Shoulder Belt Retractor into locking
mode by pulling theShoulder Belt out
all the way. In some vehicles the buckle
locks. Check the vehicle Owner’s Manual
to see how your system locks.
To check if the vehicle belt is locked,
after you install the Infant Car Seat, pull
up rmly on the Lap Belt between the
Lap Belt Guides. The belt should remain
tight if the vehicle system is locked.
ee
rr
AA