25
Outer Seating Positions
Use the lower LATCH anchors OR a vehicle seat belt to install the child restraint in outboard
seating positions (those on either side of the center position).
NEVER use LATCH together with the vehicle belts to install this child restraint. Using both is not
approved and may cause improper performance of the child restraint.
Center Seating Positions
If your vehicle does not have Lower Anchors in the center seating position, check your Vehicle
Owner’s Manual to see if you are allowed to use the two inner Lower Anchors from the outboard
seating positions to install a Child Restraint.
CYBEX allows this child restraint to be installed using
the two inner Lower Anchors from the outboard seating
positions if the distance between the inner Lower Anchors
is between 11 and 20 inches (28-51 cm) AND if your vehicle
manufacturer allows it. (If distance is not correct and/or not
allowed by vehicle manufacturer, use the vehicle belt for
installation in the center position.)
When using the inner Lower Anchors make sure there are
no obstructions from a buckle stalk for the installation and
that the LATCH straps or connectors do not block vehicle belt buckles.
11- 20 in.
28 - 51 cm
USING LATCH
To Next Page
Loading...
Need help?
General
